DiscSox^®Products: How to Use

1. Determine how you would like to divide your drawer. You can use either DiscSox sleeves or ChestStoppers as a guide to determine the minimum width of a row.

2. Measure inside depth of drawer.

3. Subtract 1/4" from the drawer depth measurement for self-adhesive clips. This will make sure the divider will fit into the designated space when cut.

4. Transfer the depth measurement - 1/4" and mark all DrawerDividers.

5. Score the DrawerDivider with a scratch awl or sharp knife.

6. Break DrawerDivider at the score line.

7. Cut self-adhesive Velcro Strips (2) to the same length as the drawer depth.

8. Clean inside of drawer with rubbing alcohol to make sure the self-adhesive components will adhere strongly to the drawer.

9. Use a ChestStopper (1) as a guide to place self-adhesive Velcro strips (2) in the middle of the space required for DiscSox sleeves.

10. Attach self-adhesive clips at each end (3) and in the middle (4) of the DrawerDivider

11. Insert DrawerDivider, including clips, in drawer and mark positions of all clips in the drawer.

12. Separate clips from DrawerDivider, remove self-adhesive protection papers from clips and set clips in the previously marked positions.

13. Insert DrawerDivider in clips, then proceed to the next row and repeat steps 5-11.