STEP 1
Place the LONG BASE and SHORT BASE sections on a table (as shown). Slide the two bases into each other until the base BUTTONS snap into place. Add additional bases (sold separately) as needed.

STEP 2
Slide the FRONT PANEL into the base section until the FRONT PANEL buttons snap into place.

STEP 3
Position the ANGLED BACK PANEL in a SLOT that corresponds with the total number of sleeves to be stored.

Place the 8 self-adhesive NON-SKID PADS into the rings at the bottom of each base.

Do not lift tray by the ANGLED BACK PANEL

Optional Assembly
Use SHORT or LONG BASE separately to make smaller trays.

Optional Assembly with Extensions
Use additional SHORT and/or LONG BASES to extend the tray to desired length.

To Separate
Hold snap-fitted bases (or base and front panel) as shown. Pull apart in opposite directions to safely disassemble tray*.

*Note: Material is flexible and not prone to breakage.